Vanguard EZCT-S2A User Manual
Page 58
EZCT S2A USER’S MANUAL
REV 1
54
3.4.6. Erasing Test Plans From a USB Flash Drive
To erase one or all test plans stored on a USB Flash drive:
a. Make sure the USB Flash drive is inserted in the EZCT S2A’s USB Flash drive port (“USB
MEM” port). Then start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the
[6]
key (ERASE TEST PLAN).
c. The following screen will be displayed:
Press the
[2]
key (ERASE THMB DRV PLAN).
d. The following screen will be displayed:
erase test plan
1. Erase single plan
2. erase all plans
1. Erase internal plan
2. erase thmb drv plan
1.
load test plan
2.
unload test plan
3.
plan directory
4.
extract test plan
5.
print test plan
6.
erase test plan
7.
copy to thumb drive
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC