11 system menu, System menu, see section 3.11 – INFICON SQC-310 Thin Film Deposition Controller User Manual
Page 61
3 - 19
IP
N 07
4-
55
0-
P1
B
SQC-310 Operating Manual
Backup: This sensor is selected solely for use as a backup sensor. It may not
be used or selected as a sensor for a film but may be used in the event of a
sensor failure. Timed Power mode will be enabled if this is the last sensor to
fail.
Crystal Position: The desired crystal position in a multi-crystal sensor head.
Backup Sensor: The designated sensor is to be used as a backup in the event of
the main sensor failing. For example, if this setting is set to "2" under Sensor 1,
Sensor 2 will be used as a backup when Sensor 1 fails. This will automatically set
Snsr 2 Crystal Fail Mode to "Backup".
Backup Crystal Position: The position on the backup the sensor where the
backup crystal is located.
3.11 System Menu
The System Menu contains settings that affect the basic operation of the SQC-310.
System parameters generally pertain to the physical setup of your vacuum system
equipment.
Figure 3-15 System Parameter Menu