INFICON SQC-310 Thin Film Deposition Controller - Manual (Page 80)

4 - 4
IP
N 07
4-
55
0-
P1
B
SQC-310 Operating Manual
Attach the rack mounting ears with the 10-32 flat-head screws provided. Carefully
lift the assembly into a full width, 5¼ in. high rack space. Attach the assembly to
the rack with 10-32 screws (not provided).
4.7 Handheld Remote Controller
The Handheld Controller (PN 782-900-017) provides the capability of adjusting
output power remotely when the SQC-310 is in Manual Mode.
Figure 4-3 Handheld Remote Controller
To use the handheld controller, attach the cable from the handheld controller to the
Remote jack on the SQC-310 front panel. Select a Process using the SQC-310
front panel SoftKeys. Press Next Menu until the Auto/Manual SoftKey is displayed.
Press Auto/Manual to change to Manual power mode (SoftKey shows
Manual/Auto). Press Start to begin the film deposition.
You can now use either the front panel Control Knob or the Handheld Controller to
adjust output power. Pressing Abort on the handheld controller stops the layer and
returns output power to 0%.
ABORT
Sigma
instruments

Handheld Controller