Lenze E84AVSCx 8400 StateLine C - Manual (Page 21)

Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
21
5 Before commissioning
5.3 General notes on applications
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.3 General notes on applications
The technology applications integrated in the drive controller provide the main signal flow for the
implementation of a general or a special drive solution.
Basic components of a drive solution
A drive solution consists of the following basic components:
• Signal inputs (for control and setpoint signals)
• Signal flow of the technology application
• Signal outputs (for status and actual value signals)
[5-4] Basic components of a drive solution
Technology application "Actuating drive speed"
This technology application preset in C00005 serves to solve speed-controlled drive tasks, e.g.
conveyor drives (interconnected), extruders, test benches, vibrators, travelling drives, presses,
machining systems, metering units.
Technology application "actuating drive speed (AC Drive profile)"
This technology application selectable
from version 13.00.00 in C00005, enables a speed or torque
control via "AC Drive profile". The fieldbuses EtherNet/IP™ and system bus (CANopen) are
supported.
"Switch-off positioning" technology application
This technology application to be selected in C00005 is used to solve speed-controlled drive tasks
which require a pre-switch off or stopping at certain positions, e.g. roller conveyors and conveying
belts.

Detailed information on each application can be found in the reference manual of the
8400 StateLine in the "Technology application"chapter .
M
...
M
n
t
и з
Switch-off positioning
Actuating drive speed
Setpoint
generator
Process
controller
Motion
Control
Kernel
Device
control
Motor
control
Signal
inputs Signal
outputs