Lenze E84AVSCx 8400 StateLine C - Manual (Page 28)

6 Commissioning
6.2 Quick commissioning with the keypad
28
Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4. Load Lenze setting to controller.
This step is recommended to get a defined device configuration. All parameter settings in the
controller are reset to the Lenze setting.
The Lenze setting can only be loaded if the controller is inhibited!
Now the Lenze setting is being loaded and then the controller will be restarted.
After attaching the keypad or switching on the
controller with keypad attached, the connection
between keypad and controller is established.
The connection has been established when the
code C00051 appears in the display.
• Then press the function key  to change to the
main menu.
• Use the / navigation keys to select the "Code
list" entry.
• Change to this level by pressing the navigation
key .
• The code list contains all parameters of the
controller.
• The "Load Lenze setting" device command
(C00002/001) is the first parameter in the code
list.
• Use the  function key to switch over to the
editing mode.
• Use the / navigation keys to select the
"1 On / Start" entry.
• Use the  function key to accept the selection
and to leave the editing mode.
Actual speed
C00051
0 rpm
CINH
Par1 8400 StateLine C
SAVE
Code list
Go To Param
USER - Menu
CINH
Load Lenze setting
C00002/001
Off / Finished
CINH EDIT
Load Lenze setting
ESC
1 On / Start
4 Action cancelled
0 Off / Finished
CINH OK
C00002/001