3 settings on the controller (slave), Settings on the controller (slave) – Lenze 931K User Manual
Page 20
Advertising
Commissioning
Settings on the controller (slave)
l
20
KHB 13.0004−EN 2.1
6.3
Settings on the controller (slave)
)
Note!
The controller parameters are set using the »Small Drives Control (SDC)« PC
software.
ƒ
Establish an RS232 connection for communication between the PC and the
controller. For a detailed description please refer to the controller’s software
manual.
ƒ
Save all settings in the parameter set of the controller using the command
File
W Parameter set W Save parameter set (flash) to prevent the settings
from getting lost in the case of a reset or mains switching.
Advertising
This manual is related to the following products: