Lenze 931K - Manual (Page 72)

Appendix
Table of parameter numbers (PNU)
10
l
72 KHB 13.0004−EN 2.1
Characteristics Possible settings Name PNU
Description Selection Lenze
Name PNU
1290 Motor Data Overload protection for the
motor connected.
0 iit Time Motor 2000 0 {1 ms} 10000 Ċ UNIT16 RW Ċ
Time for which the motor is
fed with the specified
maximum current.
l When the time has
elapsed, the motor
current is automatically
limited to the rated
current set.
1 iit Ratio Motor {1 ‰} Ċ UNIT16 RO Ċ
Reading−out of the actual
utilisation of the I
2 t
limitation.
1350 0 Enable Logic 0 Ċ UNIT16 RW Ċ
Controller is enabled via: Selection of the source for
controller enable
0 Digital input DIN 9
1 Digital input DIN 9 and RS232
3 Digital input DIN 9 and PROFIBUS
1500 0 Operating Mode Ċ UINT8 RO Ċ
00
h
Speed control Reading−out of the operating
mode.
10
h
Positioning
1601 Error Code Error messages
0 Error Field 0 Ċ UINT32 RO Ċ
Error numbers 1 ... 32 of the
controller
1 Error Field 1 Ċ UINT32 RO Ċ
Error numbers 33 ... 64 of the
controller
1610 Error Management Error management
0 Error Number Ċ UNIT8 RW Ċ
1
h
{1} 40
h
Selection of the error number
for which a response is to be
set under PNU 1610.1.
Overview of error numbers:
^ 62
1 Error Reaction Code Ċ UNIT8 RW Ċ
00
h
No response Response of the controller to
an error event.
Notes on settings:
^ 62
03
h
Warning
05
h
Emergency stop
08
h
Power stage off (motor coasts to
standstill)