Lenze EVF9333 - Manual (Page 110)

l
110 EDKVF9333V DE/EN/FR 7.1
EVF9330 ... EVF9333
0Fig. 0Tab. 0
(fold−out page on the right)
Position Description
0 Controller
1 Fixing bracket for standard mounting
2 EMC shield sheet with fixing screws for shielded control cables
3 Cover with fixing screws
4 Shield clamp and strain relief for the motor cable
5 Strain relief for the PE motor cable and the feed cable for the motor temperature monitoring with PTC thermistor
or thermal contact (NC contact)
Connections and interfaces
Position Description
L1, L2, L3, PE Mains connection ^ 159
+UG, −UG DC supply ^ 159
U, V, W, PE Motor connection ^ 159
T1, T2 Connection of PTC thermistor or thermal contact (NC contact) of the motor ^ 159
X1 AIF interface (automation interface)
Slot for communication module (e. g. XT EMZ9371BC keypad)
−
X3 Jumper for setting analog input signal at X6/1, X6/2 ^ 205
X4 System bus (CAN) connection ^ 206
X5 Connection of digital inputs and outputs ^ 199
X6 Connection of analog inputs and outputs ^ 199
X8 Connection of incremental encoder with TTL level or SinCos encoder and KTY temperature sensor
of the motor ^ 207
X9 Connection of digital frequency input signal ^ 210
X10 Connection of digital frequency output signal
X11 Connection of K
SR
relay output for "safe standstill" (for variants V004 and V024 only) ^ 202
Status displays
Position LED red LED green Operating status
 Off On Controller is enabled
On On Mains is switched on and automatic start is inhibited
Off Blinking slowly Controller is inhibited
Off On Motor data identification is active
Blinking quickly Off Undervoltage or overvoltage
Blinking slowly Off Active fault