Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 281)

L
Firmware 1.37 - 09/2006 281
9400 HighLine | Parameter setting & configuration
Standard TAs
TA "Actuator – torque" | Brake control
11.3.10 Brake control
[11-24] Basic function "Brake control" (schematic diagram)
O
Tip!
Detailed information on brake control can be found in chapter "Basic drive
functions"  subchapter " Brake control ".
(C 211)
The basic function "Brake control" serves
to the wear free control and monitoring of
a holding brake.
In the simplest case, an optionally
available brake module is used.
Alternatively the holding brake can also be
controlled and monitored via the digital
inputs/outputs.
LS_ManualJog
n
t
и з
LS_Brake
n
t
LS_Limiter
n
t
LS_Quickstop
STOP
LS_Torque...
M
Torque
setpoint
n
t
LS_Stop
internal
status machine
DI2
DI6
DI7
DI8
DI1
Status
machine
(basic drive
functions)
Basic drive functions
M
v
F
и
з
Note!
In the Lenze setting the brake control is switched off to reach a safe status after
mains connection.