Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 350)

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | "Synchronism" mode"
350 Firmware 1.37 - 09/2006
L
12.3.5.5 Setpoint conditioning
[12-31] "Setpoint conditioning" function in the signal flow (schematic diagram)
This function is used for position ratio between the master shaft and the machine axis.
r Parameter setting: Tab Application parameter  Dialog level Overview  Synchronism
 Setpoint conditioning
r Configuration: Tab FB editor  FB ToolControl
n Master value with trimming
o Actual value
Œ

M
v
Slave
Real master/
Virtual master
C03006 = 0
v
t
Dj
Dj Dj
TP TP
Parameters Lenze setting
Value Unit
C02527 Motor mounting direction Motor rotating CW
C02536 Cycle 360.0000 Unit
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
Controller inhibit
active
 Delete following error C03058/20