Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 308)

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Electronic gearbox" | Operating mode "Electronic gearbox"
308 Firmware 1.37 - 09/2006
L
12.2.5 Operating mode "Electronic gearbox"
In the "Electronic gearbox" (C03006 = "0") operating mode the drive follows the master
value of the electrical shaft if the clutch is engaged.
[12-12] "Electronic gearbox" operating mode (schematic diagram)
Functions in the "Electronic gearbox" operating mode

Master value processing
 Virtual clutch
 Master value trimming
 Setpoint conditioning
O
Tip!
A description of the different functions for conditioning the master value can be
found in the following subchapters.
M
v
Slave
Real master/
Virtual master v
t
Dv
C03006 = 0
0 1 2 3