Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 346)

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | "Synchronism" mode"
346 Firmware 1.37 - 09/2006
L
12.3.5.2 Mark synchronisation (master value)
[12-28] "Mark synchronisation" function in signal flow (schematic diagram)
This function serves to carry out a mark synchronisation of the master value via touch
probe sensor.
r Parameter setting: Tab Application parameter  Dialog level Overview  Synchronism

Master value conditioning
r Configuration: Tab FB editor  FB ElectricalShaftVal
n Master value
o Master value with stretch factor
Œ 
M
v
Slave
Real master/
Virtual master
C03006 = 0
v
t
Dj
Dj Dj
TP TP
Note!
For this purpose, the touch probe sensor must be connected to the digital input
DI3!
Parameters Lenze setting
Value Unit
C03023 Master value synchronisation (TP) Deactivated
C03612 TP position (register) 0.0000 Unit
C03651 TP limit 1.0000 Unit
C03656 Hysteresis 0.0000 Unit/t 2