Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 322)

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Electronic gearbox" | Brake control
322 Firmware 1.37 - 09/2006
L
12.2.12 Brake control
[12-22] Basic function "Brake control" (schematic diagram)
O
Tip!
Detailed information on brake control can be found in chapter "Basic drive
functions"  subchapter " Brake control ".
(C 211)
The basic function "Brake control" serves to the wear free
control and monitoring of a holding brake.
In the simplest case, an optionally available brake module
is used.
Alternatively the holding brake can also be controlled and
monitored via the digital inputs/outputs.
M
LS_Brake
Note!
In the Lenze setting the brake control is switched off to reach a safe status after
mains connection.