Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 352)

9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | "Synchronism" mode"
352 Firmware 1.37 - 09/2006
L
TP profile parameters
r Parameter setting: Tab Application parameter  Dialog level Overview  Synchronism

TP profile parameter
r Configuration: Tab FB editor  FB MarkSynchronizationTool
TP interface
r Parameter setting: Tab Application parameter  Dialog level Overview  Synchronism
 TP interface
Parameters Lenze setting
Value Unit
C03855 Positioning mode 0
C03856 Deactivation mode 0
C03858/1 Positive speed 1000.0000 Unit/t
C03858/2 Negative speed 1000.0000 Unit/t
C03861/1 Acceleration ramp 1.000 s
C03861/2 Deceleration ramp 1.000 s
C03861/3 Stop ramp 1.000 s
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
FALSE  Activate tool TP correction C03058/23
Parameters Lenze setting
Value Unit
C02810/2 Signal delay TP2 0 μs
C03031 Edge evaluation of positive edge TRUE
C03032 Edge evaluation of negative edge FALSE