MacDon FD70 for Combine Operators - Manual (Page 105)

SECTION 9. OPERATION
Form 169006
103
Revision D
c. Re-position right arm cylinder (Double Reel) as
follows:
1. Remove bolts (H) that secure plate (J), and
remove plate.
2. Remove bolts (K) so that front plate (L) is
free to move up.
3. Lift the aft end of the cylinder out of support
assembly, and move the cylinder so that
cylinder center port fitting (T) engages the
support assembly.
NOTE
Loosen a hose fitting to allow
movement of cylinder. Be sure to
re-tighten fitting after cylinder
installation.
4. Re-install plates (J) and (L) with bolts (H) and
(K) respectively.
d. Re-position right arm cylinder (Single Reel) as
follows:
1. Remove bolt and nut (M), and four bolts (N)
securing hose shield (O).
2. Move hose shield and hoses away from
cylinder.
3. Remove bolts (P) that secure aft plate (Q),
and remove the plate.
4. Remove bolts (R) so that front plate (S) is
free to move up.
(continued next page) T
RIGHT
ARM
SHOWN
L
J
RIGHT ARM - DOUBLE REEL
H
J
RIGHT ARM - DOUBLE REEL
K
L
RIGHT ARM - SINGLE REEL
S
R
RIGHT ARM - SINGLE REEL
M
O
Q
P
N