MacDon FD70 for Combine Operators - Manual (Page 165)

SECTION 10. MAINTENANCE AND SERVICING
Form 169006
163
Revision D
10.9.4 Auger Tine Replacement
The CA20 Combine Adapters are fitted with tines
to accommodate a wide variety and sizes of
combines.
Some conditions may require the removal or
addition of tines for optimal feeding of the crop.
In addition, tines that become worn or damaged
should be replaced.
To simplify the procedure, detach header from
combine.
Refer to Section 7 HEADER ATTACHMENT/
DETACHMENT.
10.9.4.1 Tine Removal
a. Remove screws (A), and remove access cover
(B).
b. From inside the auger, remove hairpin (C), and
pull tine (D) out of bushing (E).
c. From inside the auger, swivel tine away from
bushing, pull from plastic guide (F), and remove
from auger.
NOTE
If the sixth tine (D) opposite drive side is
being replaced, it also must be slipped
off drive tube (G). This particular tine
cannot be removed for normal
operation.
d. Remove screws (H) securing plastic guide (F) to
auger, and remove guide from inside auger.
e. Position cover (J) from inside auger over hole,
and secure with screws (K). Coat screws with
Loctite® #243 (or equivalent), and torque to
75 in·lbf (8.5 N·m).
F
E
D
C
B
A
F
H
J
K
G
D