MacDon FD70 for Combine Operators - Manual (Page 43)

SECTION 7.4 JOHN DEERE 60, 70 SERIES
Form 169006
41
Revision D
2. Locate coupler (G) onto receptacle, and pull
handle (A) so that lugs on coupler are
engaged into handle.
3. Pull handle to “full horizontal position” as
shown.
4. Slide latch (K) to lock handle in position, and
secure with lynch pin (L).
l. Rotate disc (M) on adapter driveline storage
hook, and remove driveline from hook.
m. Pull back collar (N) on end of driveline, and push
onto combine output shaft (O) until collar locks.
n. If adapter is equipped with reel fore-aft/header tilt
selector, connect harness (P) to combine.
NOTE
Connector (P) may need to be retrieved
from hydraulics compartment access
hole (Q).
o. Disengage both adapter float locks by moving
latch (O) away from adapter, and moving lever
(R) at each lock to “lowest position”.
M
L
K
A
G
O
LOCK
UNLOCK
R
Q
P
O
N