MacDon FD70 for Combine Operators - Manual (Page 45)

SECTION 7.4 JOHN DEERE 60, 70 SERIES
Form 169006
43
Revision D
f. Disconnect hydraulic/electrical coupler (G) from
combine as follows:
1. Remove lynch pin (H), and slide lock (J) to
release handle (K).
2. Lift handle (K) to “full vertical position” to
release coupler (G) from combine.
3. Lift handle (L) on adapter, position coupler in
adapter at (M), and lower handle (L) to lock
coupler.
g. Push handle (K) toward feeder house to
disengage feeder house pin (N) from adapter.
h. Lower feeder house until saddle (O) disengages
and clears adapter support (P).
i. Slowly back combine away from adapter.
H
J
K
G
M
L
K
P
O
N