MacDon FD70 for Combine Operators - Manual (Page 123)

SECTION 9. OPERATION
Form 169006
121
Revision D
9.18.4 Converting from Field to Transport
Position
Raise header fully, and proceed as follows:
DANGER
To avoid bodily injury or death from
unexpected start-up or fall of raised header,
stop engine, remove key, and engage header
lift cylinder stops before going under header
for any reason.
9.18.4.1 Left Wheels To Transport Position
CAUTION
Stand clear of wheels and release linkage
carefully as wheels will drop once the
mechanism is released.
a. Remove clevis pin (A).
b. Pull latch handle (B), and disengage link (C) from
lug (D) to lower wheels.
c. Place suspension assembly in “full upward
position” (E) in leg, and lower handle (F) to lock.
d. Remove pin (G) from storage at top of leg, move
and swivel wheels clockwise so that lug (D) faces
forward.
e. Insert pin (G), and turn pin to lock.
f. Locate tow-bar (H) onto axle, and push against
latch (J) until tow-bar pins drop into hooks (K).
g. Check that latch (J) has engaged tow-bar.
h. Install clevis pin (A), and secure with hairpin.
i. Connect plug (L) for lights. FIELD TO TRANSPORT - LH SIDE
Lock
E
F
H
A
J
K
FIELD TO TRANSPORT - LH SIDE
FIELD TO TRANSPORT - LH SIDE
FIELD TO TRANSPORT - LH SIDE
G
L
D
FIELD TO TRANSPORT - LH SIDE
D
B
A
C