MacDon FD70 for Combine Operators - Manual (Page 159)

SECTION 10. MAINTENANCE AND SERVICING
Form 169006
157
Revision D
10.8.2 Driveline Installation
IMPORTANT
If combine output shaft splines match
adapter input shaft splines, ensure
driveline is installed with longer guard at
adapter gearbox end.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
a. Slide driveshaft in hook (E) so that disc (D) drops
to secure driveshaft.
b. Slide shield (B) over driveline.
c. Locate driveline quick disconnect onto adapter
gearbox shaft, pull back collar and slide onto
shaft until yoke locks onto shaft. Release collar.
d. Position shield (B) on gearbox and secure with
nuts (A).
e. Re-connect other end to combine if necessary.
10.8.3 Guard Removal
The main driveline guard normally remains
attached to the driveline.
If removal is required for maintenance, proceed
as follows:
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
NOTE
The driveline does not need to be
removed from the adapter in order to
remove the driveline guard.
a. Rotate disc (D) on adapter driveline storage hook
(E), and remove driveline from hook.
b. Lift combine end of driveline (F) from hook, and
extend driveline until it separates. Hold adapter
end of driveline to prevent it from dropping and
hitting the ground.
c. Release grease zerk/lock (G) with a screwdriver.
(continued next page)
D
E
B
C
A
F
G