MacDon FD70 for Combine Operators - Manual (Page 33)

SECTION 7.2 CASE IH 7010, 8010, 7120, 8120, 88 SERIES
Form 169006
31
Revision D
3. Remove coupler (L) from combine, and clean
mating surfaces.
4. Position onto adapter receptacle (G), and
push handle (K) to engage coupler pins into
receptacle.
5. Push handle to “closed position” until lock
button (J) snaps out.
g. Remove cover on adapter electrical receptacle
(N). See illustration on previous page.
h. Remove electrical connector (M) from storage
cup on combine, and route to adapter receptacle.
i. Align lugs on connector with slots in receptacle,
push connector onto receptacle, and turn collar
on connector to lock it in place.
j. Rotate disc (O) on adapter driveline storage
hook, and remove driveline from hook.
k. Pull back collar (P) on end of driveline, and push
onto combine output shaft (Q) until collar locks.
l. Disengage both adapter float locks by moving
latch (R) away from adapter, and moving lever
(S) at each lock to “lowest position”.
S
LOCK
UNLOCK
R
J
G
K
M
O
Q
P
L
M