MacDon FD70 for Combine Operators - Manual (Page 75)

SECTION 8.2 FD70 FLEXDRAPER AND ADAPTER
Form 169006
73
Revision D
m. Disconnect hook type hydraulic center-link as
follows:
1. Lift release (M), and latch it in “up position”.
2. Extend center-link cylinder to disengage hook
from header. Stop engine, and remove key.
3. Prop up center-link with a pin (or equivalent
tool).
4. Go to step o. in next column.
n. Disconnect eye type hydraulic center-link as
follows:
1. Remove pin (N), and lift center-link clear of
bracket.
2. Replace pin (N) and secure with lynch pin.
NOTE
Feeder house may need to be raised or
lowered, or length of link adjusted to
relieve load on link.
o. Disconnect knife and draper drive hydraulic
hoses.
p. If quick disconnects are installed, disconnect as
follows:
1. Line up slot (O) in collar with pin (P) on
connector.
2. Push collar toward pin, and pull connector to
disengage.
3. Install plugs or caps on hose ends (if
equipped).
q. Disconnect electrical connector by turning collar
counter clockwise, and pulling connector to
disengage.
r. Store and secure hoses on adapter.
(continued next page)
M
N
DRAPER DRIVE
RETURN
ELECTRICAL
KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
P
O