MacDon FD70 for Combine Operators - Manual (Page 95)

SECTION 9. OPERATION
Form 169006
93
Revision D
c. Set center-link to mid-range (B to C on float/angle
indicator if installed). Adjust cutterbar to 6 - 10
inches (150 - 250 mm) above the ground.
d. If header is equipped with stabilizer wheels or
slow speed transport wheels, raise them off the
ground so they are supported by the header.
e. Remove special torque wrench (D) from storage
position at RH side of adapter frame. Pull slightly
in direction shown to disengage wrench from
hook.
f. Place torque wrench (D) onto float setting
indicator (E). Note position of wrench for
checking RH or LH side.
g. Push down on wrench until bell crank (F) rotates
forward. Check the position of the wrench
indicator (G) near the handle. Repeat for
opposite side.
Use the table below as a guide for float settings.
HEADER
WIDTH
TORQUE SETTINGS
CUTTING ON
THE GROUND
CUTTING OFF
THE GROUND
20, 25, 30
and 35 FT
2 2 1/2
40, 45 FT 2 1/2 3
(continued next page)
D
G
D
LEFT SIDE
F
E
D
E
RIGHT SIDE - BELL CRANK NOT SHOWN