MacDon FD70 for Combine Operators - Manual (Page 66)

SECTION 8.1 D50, D60 HEADER AND ADAPTER
Form 169006
64
Revision D
e. Lower stand (F) by pulling spring loaded pin (G).
Release pin when stand at desired height.
f. Remove pin (H) from leg on both sides of
adapter.
g. Disconnect hook type hydraulic center-link as
follows:
1. Lift release (J) and latch it in “up position”.
2. Extend center-link cylinder to disengage hook
from header.
3. Prop up center-link with a pin (or equivalent
tool).
h. Disconnect eye type hydraulic center-link as
follows:
1. Operate center-link hydraulics until pin (K) is
loose.
2. Remove pin (K), and lift center-link clear of
bracket.
3. Replace pin (K), and secure with lynch pin.
i. Disconnect mechanical link as follows:
1. Remove pin (L) to release link. Replace pin.
NOTE
Feeder house may need to be raised or
lowered, or length of link adjusted, to
relieve load on link.
j. Disconnect knife and draper drive hydraulic
hoses. Install caps and plugs on fittings.
(continued next page)
K
J
L
QUICK DISCONNECTS SHOWN
DRAPER DRIVE
RETURN
ELECTRICAL KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
H
G
F