MacDon FD70 for Combine Operators - Manual (Page 39)

SECTION 7.3 CASE IH 2300, 2500 SERIES
Form 169006
37
Revision D
7.3.2 Detachment
a. Choose a level area. Position header slightly
above ground. Stop engine, and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s Manual
for instructions for use and storage of header
lift cylinder stops.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
b. Engage both adapter float locks by lifting lever (A)
at each lock until it latches into the “lock position”.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached in
either Transport or Field mode. If
detaching with wheel in Field mode, set
wheels to storage or “uppermost
working position”. Otherwise header
may tilt forward so that re-attachment
will be difficult. Refer to Section 9.11.2
Cutting Height.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or “uppermost
working position:. Otherwise header
may tilt forward so that re-attachment
will be difficult. Refer to Section 9.11.2
Cutting Height.
c. Open guard (B).
d. Pull back collar (C) on driveline, and pull driveline
off combine shaft. Close guard (B).
e. Slide driveline in hook (D) so that disc (E) drops
to secure driveshaft.
f. Disconnect wiring harness (F), and attach covers
on each plug.
g. If applicable, unplug AHHC wiring harness from
connector (G).
(continued next page)
A
LOCK
UNLOCK
C
B
G
F
E
D