MacDon FD70 for Combine Operators - Manual (Page 77)

SECTION 8.2 FD70 FLEXDRAPER AND ADAPTER
Form 169006
75
Revision D
8.2.2 Assembly
The FD70 FlexDraper can be attached to the
adapter from either Field configuration or
Transport configuration.
NOTE
Stabilizer/Transport wheels can to be
used in combination with the stand to
support header. Refer to Section 9.11.2
Cutting Height.
a. Prop up hydraulic center-link (A) with pin or
equivalent tool.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
b. Start engine, and lower combine feeder house so
that adapter arms (B) are aligned with header
balance channel (C). Stop engine, and remove
key.
c. Remove bolts (D), washers, and spacers from
adapter legs.
d. Start engine, and slowly drive forward, again
aligning adapter arms and header balance
channel.
e. Keep adapter arm height just under the header
balance channel (C) to ensure adapter leg seats
properly in the header linkage supports.
IMPORTANT
Keep hydraulic hoses clear to prevent
damage when driving into header.
f. Continue forward until adapter arm contacts stop
in header balance channel (C).
(continued next page)
D
C
B
EYE TYPE
A
HOOK TYPE
A