MacDon FD70 for Combine Operators - Manual (Page 129)

SECTION 9. OPERATION
Form 169006
127
Revision D
NOTE
If right deck is moved, loosen clamp on
plastic sleeve at right deck drive motor
so that hoses can be reversed.
Re-tighten clamp.
IMPORTANT
The deck on 45 FT header needs to be
supported at front when re-positioning,
and requires installation of an additional
deck support.
d. Install support as follows:
1. Remove support (G) from backsheet, and
remove hardware from support. Retain
hardware.
2. Install support on lift cylinder bracket at
center of backtube with bolt and nut. Do not
tighten.
3. After deck is moved, attach backsheet to
support (G) with hardware provided.
4. Tighten bolts.
9.19.1.4 Header Attachment
a. Re-attach adapter to combine. Refer to Section 7
HEADER ATTACHMENT/DETACHMENT.
b. Re-attach header to adapter. Refer to Section 8
HEADER/ADAPTER DISASSEMBLY AND
ASSEMBLY.
c. Adjust header float. Refer to Section 9.11.3
Header Float.
d. Level header if necessary. Refer to Section 9.14
HEADER LEVELLING.
G
G
RIGHT DECK MOTOR
F