MacDon FD70 for Combine Operators - Manual (Page 127)

SECTION 9. OPERATION
Form 169006
125
Revision D
h. Tighten straps until float limiter bars (J) are
loose. Remove pins (K) at lower end of bars.
NOTE
Float limiter bars are stamped with
letter F.
i. Loosen two bolts (L) attaching feed auger to drive
shaft.
j. Disconnect hoses (M) at feed draper motor, and
re-connect ends with a 5/8 inch JIC male to male
fitting (shown in previous column).
NOTE
Mark hoses so that they are re-installed
in the matching ports when re-installing
the feed deck. Install plugs on motor
ports.
k. Loosen two bolts (N) that secure deck retaining
pins (O). There is one bolt per side.
l. Remove pins (O), and pull feed deck away.
Replace pins for re-installation.
M
L
J
K
N
O
O