MacDon FD70 for Combine Operators - Manual (Page 71)

SECTION 8.1 D50, D60 HEADER AND ADAPTER
Form 169006
69
Revision D
q. Attach adapter deck to header cutterbar as
follows:
WARNING
Keep hands clear of the area between guards
and sickle at all times.
CAUTION
Wear heavy gloves when working around or
handling sickles.
1. If installed, remove bolts (T) at either side of
opening to allow attachment of adapter deck.
2. Position latches (U) on transition pan so that
chain (W) can be attached to the latch hook.
3. Rotate latch (U) with a 15/16 wrench (or
equivalent) on hex (X) to raise feed deck so
that bolt (T) can be re-installed. Repeat for
other side of feed draper.
r. Connect knife and draper drive hydraulics as
shown above, using colored plastic ties as a
guide.
s. If quick disconnects are installed, proceed as
follows:
1. Check connectors and clean (if required).
2. Push hose connector onto mating receptacle
until collar on receptacle snaps into “lock
position”.
NOTE
Ensure hoses are clear of driveline and
adjacent structure.
t. Attach electrical connector as follows:
1. Remove cover on receptacle.
2. Align lugs on connector with slots in
receptacle, push connector onto receptacle,
and turn collar on connector to lock it in
place.
3. Attach cover to mating cover on combine
wiring harness.
(continued next page)
U
X
ELECTRICAL
RETURN
KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
DRAPER DRIVE
ELECTRICAL
T
W
U