MacDon FD70 for Combine Operators - Manual (Page 126)

SECTION 9. OPERATION
Form 169006
124
Revision D
9.19 WINDROWING
The D60 Harvest Header can be used for
windrowing with a combine, but it is necessary to
modify the CA20 Combine Adapter by removing
auger and feed deck as per the following
procedure. The auger and feed deck can be
re-attached for combining by reversing the
following procedure.
9.19.1 Adapter Modification
a. Remove header from adapter. Refer to Section
8.1.1 Disassembly.
b. Place blocks under the adapter legs on level
ground. The blocks should be the same length
as the legs to keep the adapter stable.
c. Remove adapter from combine. Refer to Section
7 HEADER ATTACHMENT/DETACHMENT.
9.19.1.1 Feed Deck Removal
a. Remove poly deflector (A) on right side of the
feed auger.
b. Remove auger drive chain (B). Refer to Section
10.9.3 Auger Drive Chain Replacement.
c. Remove drive sprocket (C).
d. Loosen eyebolt (D) on auger spring (E) until
spring can be removed. Repeat for other spring.
e. Support auger at both ends with adjustable
straps (F) as shown.
f. Loosen inboard float springs (G) until tension is
released.
g. Remove pin (H) at the lower end of the spring,
and remove adjuster bolt to remove spring. Set
aside for re-installation.
(continued next page)
A
D
E
F
G
H
C
B