Rockwell Automation 193-ETN E1 Plus EtherNet Side Mount Module User Manual - Manual (Page 18)

18 Rockwell Automation Publication 193-UM012B-EN-P - June 2011
Chapter 2
• No warning currently exists
• Comm Idle Warning is enabled
• The network controller that is communicating to the E1 Plus EtherNet/IP
Module is placed in idle mode
When the Comm Idle warning conditions are satisfied, the following will occur:
• Bit 6 in Parameter 4, Warning Status, will go to “1”
• Bit 1 in Parameter 10, Device Status, will go to “1”
IMPORTANT The Comm Idle State of OUT A is defined by Parameter 38 (OUTA En
IdlState) and parameter 39 (OUTA En IdlValue).