Device parameters and tags, Introduction, Parameter and tag programming – Rockwell Automation 193-ETN E1 Plus EtherNet Side Mount Module User Manual User Manual
Page 63: Program lock, Resetting to the factory default values, Introduction parameter and tag programming, Chapter
Rockwell Automation Publication 193-UM012B-EN-P - June 2011
63
Chapter
6
Device Parameters and Tags
Introduction
The E1 Plus EtherNet/IP Side Mount Module allows the Parameter Object to
respond to explicit messages using the MSG instruction from Logix Controllers
and SLC-500/MicroLogix controllers. The module also supports the Symbolic
Object, which allows software packages such FactoryTalk View to communicate
directly to the E1 Plus EtherNet/IP Side Mount Module as if it were a Logix
Controller with predefined tags. This chapter describes each parameter and tag.
Parameter and Tag
Programming
Refer to Chapter 3,
Configure an E1 Plus EtherNet/IP Module To Operate on the
Network, for instructions to modify EtherNet/IP parameter settings.
Program Lock
Parameter 24,
Program Lock, provides a degree of security from having parameter
settings unintentionally altered when programmed to the “locked” setting.
Resetting to the Factory Default Values
Parameter 25,
Set to Default, allows the installer to reset all parameter settings
(including trip logs) to the factory default values.
IMPORTANT
Parameter setting changes to the E1 Plus EtherNet/IP Module take
effect immediately even during a “running” status.
IMPORTANT
Resetting to factory default values also resets the E1 Plus EtherNet/IP
Module’s IP and DHCP settings.