Start the mac scanner software, Scan the subnet for all available mac addresses – Rockwell Automation 193-ETN E1 Plus EtherNet Side Mount Module User Manual User Manual
Page 22
22
Rockwell Automation Publication 193-UM012B-EN-P - June 2011
Chapter 3
Assign Network
Parameters Via a Web
Browser and MAC Scanner
Software
In the event that a user does not have access to a DHCP software utility, a user
can assign network parameters via a web browser, such as Microsoft’s Internet
Explorer, and Media Access Control (MAC) scanner software, such as MAC
Scanner from Colasoft -
http://www.colasoft.com/
. Follow these steps to
configure the module using this method.
1.
Locate and identify the MAC ID printed on the label of the E1 Plus
EtherNet/IP Side Mount Module. This address has a format that is similar
to: 00-0b-db-14-55-35
2.
Connect the E1 Plus EtherNet/IP Side Mount Module to the same Wide
Area Network (WAN) as your personal computer.
3.
Start the MAC scanner software
4.
Select the appropriate subnet to scan for available MAC addresses.
5.
Scan the Subnet for all available MAC addresses.
6.
Identify the IP address assigned to the MAC ID of the E1 Plus EtherNet/
IP Side Mount Module. The IP address will have a format that is similar to
192.168.0.100.