Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 123)

7 • T RANSFERRING D ATA
113
Shutting Down the Data Transfer Service
When Data Transfer receives a shut down signal from the FactoryTalk Historian ME
system, it records it in the system log and changes its status on the Data Transfer page
to Stopped.
Configuring Data Transfer
To configure the Data Transfer service, click Configure Historian in the top
navigation bar, and then click Data Transfer in the left navigation bar.
Prerequisite Information
Before transferring data, you must:
„
Ensure that you have administrator privileges and other necessary security
settings configured to enable the Data Transfer service in FactoryTalk Historian
ME.
„
Ensure that your system has time synchronization set up and configured for
FactoryTalk Historian ME, controllers, the FactoryTalk Historian SE or PI server
and clients.
„
Ensure that the proper licenses (using FactoryTalk Activation) are installed and
configured (through the FactoryTalk Administration Console) on the FactoryTalk
Historian SE.
„
Ensure that trust connections between FactoryTalk Historian ME and the
FactoryTalk Historian SE or PI server are set up and configured properly before
you begin transferring data.
See the “Managing Security” chapter for security administration information.
See the “Managing Time” section for more information about trust configuration.
See the “Installing FactoryTalk View SE Patch” section for more information about
installing the FactoryTalk Historian SE patch necessary to transfer data from
FactoryTalk Historian ME.
See the “Managing Security Trusts” section for more information about trust
configuration.