Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 267)

257
D
RSLogix 5000 Add-on Profile
The RSLogix 5000 Add-on Profile (AOP) enables integration between a
ControlLogix controller and the FactoryTalk Historian ME module. To configure
your module in AOP, you need to add the module to the I/O Configuration folder of a
project in RSLogix 5000, and then add Ladder logic to your project.
This appendix includes these sections:
„
“Using AOP: Sample Scenario”
This section illustrates a sample scenario in which AOP allows a controller in the
local chassis to monitor key FactoryTalk Historian ME statistics and control Data
Collection start and stop. It demonstrates that a Ladder programmer can write
controller logic that uses:
‡
Input tags to FactoryTalk Historian ME to monitor key statistics.
‡
Output tags to make control decisions. The Output tags can determine whether
or not to allow Data Collection to start or stop in FactoryTalk Historian ME.
They can also determine if FactoryTalk Historian ME shuts down or starts up.
„
“Using the AOP Module Properties Configuration Tab”
This section describes how to use AOP to restore defaults, reset security, shut
down or start up your FactoryTalk Historian ME module after it has been
configured in AOP.
The FactoryTalk Historian ME AOP is available on the module Client Tools CD.
Insert the CD into your computer’s CD drive. If autoplay is turned on, the
FactoryTalk Historian ME installation screen will automatically launch and display
the FactoryTalk Historian ME installation options. If the screen does not
automatically launch, click Start > Run and type D:\setup, where D is the letter of
your CD drive.To access the FactoryTalk Historian ME Client Tools, click Install ME
Client Tools from the main menu. This takes you to the Installation menu. Click
Install FactoryTalk Historian ME RSLogix 5000 Module Profile to install AOP. Using