Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 166)

F ACTORY T ALK H ISTORIAN ME M ODULE U SER ’ S G UIDE
156
Module shutdown is complete when the scrolling message on the module displays the
module’s IP address followed by SHUTDOWN.
You can also shut down the module using the FactoryTalk Historian ME Add-on
Profile (AOP) in RSLogix 5000.
Restarting the Module
To restart the module, you can:
„
Remove it from the chassis and reinsert it into the chassis.
„
Cycle the chassis power.
„
Use the FactoryTalk Historian ME AOP in RSLogix 5000.
See “Using the AOP Module Properties Configuration Tab” for more information.
Cycling the power on the chassis will cause FactoryTalk Historian ME to shut
down. Do not cycle the power unless you have first shut down the module. To shut
down the module, click Advanced in the top navigation bar, and go to the Module
Shutdown page. Click [Module Shutdown].
See “Using the AOP Module Properties Configuration Tab” for more information.
Remove the module
from the chassis after
executing the [Module
Shutdown] command.