Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 187)

9 • M ANAGING S ECURITY
177
To test the module’s connection to the FactoryTalk Historian SE server where the
web applications and data transfer trusts you just created reside, perform the
following steps.
1. Go to the FactoryTalk Historian SE/PI Server Parameters section.
2. Enter the host name or IP address of your FactoryTalk Historian SE server in the
Host Server field.
3. Click [Test Connection].
An informational message that states that the connection to SE was established
displays at the top of the page if the connection is successful. In addition, a green
checkmark displays next to the [Test Connection] button. This indicates that the
module can establish a connection to your FactoryTalk Historian SE server. If this
checkmark and message do not appear, check your work and try again.
4. Click [Save].
You have completed the trust configuration process.
Ensure that licenses
to support the FTMS
point source have
been activated on the
FactoryTalk
Historian SE server
before you configure
Data Transfer.