Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 35)

2 • G ETTING S TARTED
25
Installing FactoryTalk Historian ME Client Tools
After you have selected the platform that best suits your needs and have installed
FactoryTalk Historian ME into the chassis, you will then determine the configuration
environment for the FactoryTalk Historian ME client tools. The client tools can be found on
the CD that was shipped with FactoryTalk Historian ME.
Insert the CD into your computer’s CD drive. If autoplay is turned on, the FactoryTalk
Historian ME installation screen will automatically launch and display the FactoryTalk
Historian ME installation options. If the screen does not automatically launch, click Start >
Run and type D:\setup, where D is the letter of your CD drive.
To access the FactoryTalk Historian ME Client Tools, click Install ME Client Tools from the
main menu. This takes you to the Installation menu. The FactoryTalk Historian ME Client
Tools installation screen allows you to perform the following tasks:
„
“Installing FactoryTalk Services Platform”
„
“Installing FactoryTalk Historian Management”
„
“Installing FactoryTalk Historian ME Rule Editor”
„
“Installing FactoryTalk Historian ME RSLogix 5000 AOP”
A patch for FactoryTalk View SE and electronic data sheet (EDS) files are also available on
the Client Tools CD. However you should always check the Rockwell Technical Support
Knowledgebase to ensure that you have the latest patches.
If you plan to use FactoryTalk Historian ME Client Tools, such as the FactoryTalk Historian ME
Rule Editor, FactoryTalk Directory, and/or FactoryTalk Security, then these tools must be installed
before you continue. If you do not plan to use FactoryTalk Historian Client Tools, then skip to
“Logging In to FactoryTalk Historian ME”.
See the “Installing FactoryTalk View SE Patch” and “FactoryTalk Historian ME EDS Files”
sections for information.