Rockwell Automation 1756-HIST2G FactoryTalk Historian ME 2.2 - Manual (Page 131)

7 • T RANSFERRING D ATA
121
Adding Points to Transfer
The table lists all points that fit the search criteria. If the point has been created in the
FactoryTalk Historian SE or PI server, this is indicated in the table. All checked
points are tagged for transfer to the FactoryTalk Historian SE or PI server.
The table lists the following information:
„
Selected - adds the point to Data Transfer. Points that have already been added are
checked also.
„
Name - name of the data point in FactoryTalk Historian ME.
„
Type - the data type of the point.
„
Source - indicates the point source of the data point.
„
Created in SE/PI Server - the point has already been matched to the FactoryTalk
Historian SE or PI server, as indicated by Y in the Created in SE/PI Server
column. If not, this is indicated by N.
Manually Transferring Points
To map data points to the FactoryTalk Historian SE or PI server, select the points in
the table by checking the checkboxes, and click [Save]. To confirm the points have
been mapped to the FactoryTalk Historian SE or PI server, click [Search]. The points
you selected for mapping should have a Y in the Created in SE/PI Server column.
Removing Points from Data Transfer
If you no longer want to transfer data for a point or points, clear the checkbox in the
table for those points. Note that this only removes them from the Data Transfer
service. To remove the points from the FactoryTalk Historian SE or PI server, and
thereby free up license space, you must delete the points in the FactoryTalk Historian
SE or PI server.
The Available Licensed Points value may not update immediately because it takes
approximately fifteen minutes to update the FactoryTalk Historian SE or PI server.