Rockwell Automation 1756-IF4FXOF2F ControlLogix High-speed Analog I/O Module - Manual (Page 55)

Rockwell Automation Publication 1756-UM005B-EN-P - January 2013 55
Chapter
4
Install the Module
Topic Page
Install theModule 57
Key the Removable Terminal Block 59
Connect the Wiring 60
Wire the Module 63
Assemble the Removable Terminal Block and the Housing 66
Install the Removable Terminal Block onto the Module 67
Remove the Removable Terminal Block from the Module 68
Remove the Module from the Chassis 69
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not provide adequate protection to radio
communication services in such environments.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or minimize the spread of
flame, complying with a flame spread rating of 5VA or be approved for the application if nonmetallic. The interior of the
enclosure must be accessible only by the use of a tool. Subsequent sections of this publication may contain additional
information regarding specific enclosure type ratings that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1 , for additional installation requirements
• NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by enclosures