Rockwell Automation 1756-IF4FXOF2F ControlLogix High-speed Analog I/O Module - Manual (Page 77)

Rockwell Automation Publication 1756-UM005B-EN-P - January 2013 77
Configure the Module Chapter 5
Click Finish to accept the parameters
you have configured for your module. Click Next to proceed.
Click Finish to accept the
parameters you have configured
for your module. Click Next to proceed.
Click Finish to accept the
parameters you have configured
for your module. Click Next to proceed.
Choose an input channel.
IMPORTANT: Set all the parameters
for each channel before proceeding.
Set the scaling ( page 36 ).
Set the RTS rate ( page 18 ).
This setting affects the entire
module, not just a single channel.
To use sub-millisecond values, type
values with a decimal point. For
example, to use 800
μ
S, type 0.8.
Choose a range for the input
(
page 38 ).
Set the digital filter time
(
page 43 ).
Choose an input channel.
IMPORTANT: Set all the parameters
for each channel before proceeding.
Set process alarms ( page 44 ).
During module operation, the Unlatch
buttons are enabled, once set. Click
the button to unlatch alarms.
Disable all alarms.
Latch process alarms
(
page 44 ).
Latch the rate alarm
(
page 45 ).
Set the deadband
(
page 44 ).
Set the rate alarm
(
page 45 ).
Choose an output channel.
IMPORTANT: Set all the parameters for
each channel before proceeding.
Set the scaling ( page 36 ).
Choose a range for the
output (
page 46 ).
If necessary, enable Hold
for Initialization (
page 47 ).
Synchronize module inputs
(
page 45 ).