Rockwell Automation 1756-IF4FXOF2F ControlLogix High-speed Analog I/O Module User Manual
Page 67
Rockwell Automation Publication 1756-UM005B-EN-P - January 2013
67
Install the Module
Chapter 4
Install the Removable
Terminal Block onto
the Module
Install the RTB onto the module to connect wiring.
Before installing the RTB, make sure of the following:
•
The field-side wiring of the RTB has been completed.
•
The RTB housing is snapped into place on the RTB.
•
The RTB housing door is closed.
•
The locking tab at the top of the module is unlocked.
1.
Align the top, bottom, and left-side guides on the RTB with matching
guides on the module.
2.
Press quickly and evenly to seat the RTB on the module until the latches
snap into place.
3.
Slide the locking tab down to lock the RTB onto the module.
ATTENTION: Be sure that power is removed or the area is nonhazardous before
proceeding.
WARNING: When you connect or disconnect the Removable Terminal Block
(RTB) with field side power applied, an electrical arc can occur. This could cause
an explosion in hazardous location installations.
20853-M
RTB
Module
Bottom Guide
Left-side Guides
Top Guide
20854-M
Locking Tab