Rockwell Automation 1756-IF4FXOF2F ControlLogix High-speed Analog I/O Module - Manual (Page 76)

76 Rockwell Automation Publication 1756-UM005B-EN-P - January 2013
Chapter 5 Configure the Module
Alter the Default
Configuration You can specify a custom configuration by modifying a series of parameters on
the Module Properties dialog box.
Click Next to proceed.
Click Next to proceed.
This information is used during online
monitoring, but not initial configuration.
Adjust the requested packet interval ( page 19 ).
Inhibit ( page 34 ) the connection to the module.
This Fault box is empty when you are offline.
If a fault occurs while the module is online,
the type of fault will be displayed here.
If you want a Major Fault on the Controller to occur
if there is connection failure with the I/O module
while in Run mode, check this checkbox .