Rockwell Automation 1785-Vx0B, D17856.5.9 PLC-5 VME VMEbus Programmable Controllers User Manual - Manual (Page 23)

2 Chapter
2-1
Installation
Read this chapter to learn how to set the switches in your PLC-5/VME
processor and install it into a VMEbus chassis.
See the Classic 1785 PLC-5 Programmable Controller Hardware
Installation Manual, publication 1785-6.6.1 for more information about
installing PLC-5 family processors.
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in
whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 – Industrial
Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 – Industrial
Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage,
by applying the safety requirements of EN 61131–2 Programmable
Controllers, Part 2 – Equipment Requirements and Tests.
For specific information required by EN 61131-2, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1
•
Enhanced and Ethernet PLC-5 Programmable Controller User
Manual, publication 1785-6.5.12
•
Guidelines for Handling Lithium Batteries, publication AG-5.4
•
Automation Systems Catalog, publication B111
Chapter Objectives
Compliance to
European Union Directives