Rockwell Automation 2711E-ND7 PanelView 1400E File Transfer Utility - Manual (Page 24)

2–9
Publication 2711E–6.8 – January 1998
FTU FTU32
For a DH+ transfer, a PLC-5 or SLC-5/04
processor is required (for PLC/SLC
series/revision requirements, refer to
Chapter 5 of the PanelView 1000e, 1200e,
and 1400e Operator Terminals User
Manual) For a DH+ transfer, a PLC-5 or SLC-5/04
processor is required (for PLC/SLC
series/revision requirements, refer to
Chapter 5 of the PanelView 1000e, 1200e,
and 1400e Operator Terminals User
Manual)
For a ControlNet transfer, a PLC-5
processor is required (for PLC
series/revision requirements, refer to
Chapter 5 of the PanelView 1000e, 1200e,
and 1400e Operator Terminals User
Manual) For a ControlNet transfer, a PLC-5
processor is required (for PLC
series/revision requirements, refer to
Chapter 5 of the PanelView 1000e, 1200e,
and 1400e Operator Terminals User
Manual)
For 1000e/1200e/1400e terminals,
INTERCHANGE or WINtelligent LINX is
e ui ed
For an Ethernet transfer, a PLC-5 processor
is required
RC A G o telli ent L is
required
For 1000e/1200e/1400e terminals, RSLinx
is required
Figures 2.6 and 2.7 show how the application file is transferred from
the development computer to the PLC controller and then to the
PanelView terminal. Figure 2.8 shows how the application file is
transferred through an Ethernet link, over the Remote I/O network,
and then to the PanelView terminal.
Figure 2.6 Remote I/O Pass-Through on a DH+ Network
Development Computer
DH+
1784-KT
PanelView 1400e
RIO
PLC-5
1784-CP
Cable