Rockwell Automation 2711E-ND7 PanelView 1400E File Transfer Utility - Manual (Page 67)

5–7 Configuring Communications Settings for 1000e/1200e/1400e Application Transfers
Publication 2711E-6.8 – January 1998
The RS-232 serial transfer link is used when you perform a
transfer using the COM port on your PC.
The Network Direct option performs a transfer over DH+ or
ControlNet.
The Remote I/O Pass-Through option performs transfers over
DH+ or ControlNet between the PC and PLC, and over Remote
I/O from the PLC to the PanelView terminal.
The Remote I/O Pass-Through option performs transfers over
DH+, ControlNet, or Ethernet between the PC and PLC, and over
Remote I/O from the PLC to the PanelView terminal.
Driver Selection
After you select the transfer link, refer to the following sections for
network and driver configurations.
RS-232 Serial Transfer Link Driver Configuration
When you select RS-232 Serial as the transfer link, Driver selection
is the only option you can configure.
FTU
FTU32