Rockwell Automation 2711E-ND7 PanelView 1400E File Transfer Utility - Manual (Page 77)

5–17 Configuring Communications Settings for 1000e/1200e/1400e Application Transfers
Publication 2711E-6.8 – January 1998
4. Fill in the fields in the Communication Driver Configuration
dialog box as follows:
Baud
Specify the data-transfer rate between your computer and the
PanelView terminal. This must match the baud rate configured
for the PanelView terminal. The default setting is 9600.
Port
Specify COM1, COM2, COM3, or COM4 as the serial port used
to connect the Upload/Download cable or the PanelView
terminal. The default setting is COM1.
Parity
Specify None or Even for the type of error-checking to be used.
This must match the parity configured for the PanelView
terminal. The default setting is None.
Error
Specify the error-detection protocol used by the device. BCC is
Block Check Character and CRC is Cyclic Redundancy Check.
This must match the error-checking protocol configured for the
PanelView terminal. The default setting is BCC.
For details about PanelView terminal transfer configuration
settings, see “Transferring Application Files” in Chapter 5,
“Configuring PanelView Terminals,” in your PanelView 1000e,
1200e, and 1400e Operator Terminals User Manual.
To configure Pass-Through setup parameters:
" If your transfer link is Remote I/O Pass-Through, specify
Pass-Through settings as follows:
Device
Select the PLC to which the PanelView terminal is connected
over Remote I/O. For DH+ Remote I/O Pass-Through, the default
device is PLC-5/11 Integral. For ControlNet Pass-Through, the
default device is PLC-5/20. For Ethernet Remote Pass-Through,
the default device is PLC-5/20.