Rockwell Automation 2711E-ND7 PanelView 1400E File Transfer Utility - Manual (Page 66)

5–6 Configuring Communications Settings for 1000e/1200e/1400e Application Transfers
Publication 2711E-6.8 – January 1998
If you choose Application, all parameter settings except for
Communication Driver are taken from the application file. Refer
to the PanelBuilder 1400e Configuration Software for Windows
User Manual for information on where those are configured. You
may want to use the Application setting if you are uploading
applications for maintenance and want the application to
download back to the same address.
Select Browse to select an application and Load to reload the
original settings from the application files if you have changed
them. The Browse and Load buttons are available only for
application and alarm history uploads.
For downloads, the parameter settings are taken from the file you
are downloading. For uploads and alarm history uploads, the
parameter settings are taken from the file you chose in the Mode
selection area.
Transfer Link Selection
To select the transfer link:
" Select either the RS-232, Network Direct, or the Remote I/O
Pass-Through option.
Typically, the communication hardware in your computer
determines your transfer link options. To identify your transfer
link options for your computer host hardware, refer to Table 5.A
or 5.B, “Table of PC Host Hardware and Applicable Drivers.”