Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control (PanelView 550) - Manual (Page 104)

3-44 Operator Interface
7000A-UM151D-EN-P – March 2013 7000 “A” Frame
Figure 3.59 – Modification Completed
The changes made do not take affect until you press [F10] and exit
the screen. Any time prior to this you may cancel all of the changes
made after coming to the screen by pressing the [F7] key.
PLC
The drive can be optionally connected to a PLC via a RIO (Remote
Input/Output) adapter. The drive appears to the PLC as a rack of
information. The tags that are associated with each of the words
within a rack can be defined. To setup the PLC link, use the
up/down arrow keys on the SETUP screen to select the 'PLC' option
and press the [enter] key.
This will display a screen as shown in Figure 3.60 or 3.61. The PLC
setup consists of eight words of input and eight words of output.
These are shown on separate screens. The type of PLC word being
viewed is defined to the right of the screen name, i.e. PLC SETUP:
INPUTS or PLC SETUP: OUTPUTS. To switch to the other screen,
press the [F8] key. Each press of the [F8] key will toggle the screen
to show the other set of words.
The layout of the PLC 'rack' is dependent on the DIP switch settings
on the RIO adapter, (refer to the appropriate manual for information
on the following adapters and their use: 1203-GD1, 1203-GK1,
1203-CN1, 1203-GD2, 1203-GK2, 1203-GK5, 1203-GU6, 1203-
SM1 and 1203-SSS). Tags are assigned to rack module locations in
pairs. These pairs are referred to as links and consist of two input
and two output words. There are a total of four links that can be
assigned to the RIO adapter.
The screens show the current tags and their tag code, which are
associated with each of the links. To change the tag attached to a
link, use the [cursor up] and [cursor down] keys to highlight the
desired link and press the [enter] key. (If nothing happens then you
have not gained the required access to make changes. Exit to the
SETUP screen and refer to the section entitled Enter/Modify an
Access Level to gain access).