Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control (PanelView 550) - Manual (Page 110)

3-50 Operator Interface
7000A-UM151D-EN-P – March 2013 7000 “A” Frame
The left side of the pair shows the name of the bit, while the right
side shows the current value of the bit within the parameter.
All of these values are updated from the drive on a continual basis.
From the DISPLAY screen, it is possible to modify a parameter. If
the group you are currently viewing contains parameters, press the
[F7] key. The operator interface then allows you to select the
parameter you wish to modify. Refer to the section entitled "Modify
Parameters" for further details.
If you have modified any parameters in the drive, you will be
prompted to make the changes permanent. This prompt will occur
upon exiting the DISPLAY GROUP screen. Refer to "Message
Prompting" for further details.
Custom Group
From the DISPLAY GROUP screen (Figure 3.67) you can select a
group which you have custom defined by pressing the [F7] key. This
custom group contains selected tags from one or more other groups,
arranged by you onto a single screen for more convenient viewing
(Figure 3.71).
To assign a tag to the display, use the [cursor up] and [cursor down]
keys to highlight the desired item position and press the [enter] key.
This will begin the selection process of a tag as described in the
section entitled "Select a Parameter". When you have completed
the selection process, the selected tag will be assigned to the item, as
in Figure 3.72. To remove a tag from the highlighted item, press the
[delete] (Backspace) key.
Figure 3.71 – Display Custom Screen